Skip to installation instructions

NeverSoft Cap Installation Instructions

Charge, install and set your NeverSoft valve caps in six simple steps.

Installation video

Installation steps

Use the pressure specified by your boat manufacturer when preparing your tubes and selecting your cap’s pressure mode.

  1. Charge in direct sunlight

    It is recommended to place your NeverSoft valve caps in direct sunlight for one day before installation.

  2. Pre-inflate your boat

    If not already inflated, inflate your boat’s tubes to the manufacturer’s PSI specification before installing the caps.

    NeverSoft caps maintain tube pressure; they are not intended to inflate a boat from flat.

  3. Install the NeverSoft™ cap

    Remove the original valve cap and replace it with your matching NeverSoft cap.

    Need to choose a fitting? Browse the boat and valve options in the product store.

  4. Check automatic activation

    Once installed, the cap senses pressure. The pump will run briefly and the indicator lights will flash.

    The number of blinks indicates the cap’s current mode. Follow step 5 below to select your desired setting.

View installation photos
Three installation views showing the original boat valve cap, the valve uncovered beside a NeverSoft cap, and the NeverSoft cap fitted.
Fitting sequence: original cap, exposed valve and NeverSoft cap installed. The pressure printed on this example boat is not a setting recommendation for other boats.

5. Set your pressure mode

  1. Enter programming mode. When first installed, the pump runs briefly and the lights flash to show its current mode. Remove the cap while the lights are flashing to enter programming mode.
  2. Watch the blink sequence. Each mode sequence runs for approximately 15 seconds before moving to the next mode. Use the table below to identify the setting.
  3. Select your mode. Reinstall the cap while the lights are flashing the desired mode. The LEDs will flash the selected mode sequence to confirm your selection.
Target average high pressure settings
LED sequenceModeTarget pressure
1 blinkMode 12 PSI (140 mb)
2 blinksMode 22.5 PSI (170 mb)
3 blinksMode 33 PSI (205 mb)
4 blinksMode 43.5 PSI (240 mb)

The mb values are approximate. Select the appropriate mode using your boat manufacturer’s pressure guidance.

Relax and enjoy

That’s it! Your NeverSoft cap is now set. Time to kick back and enjoy your favorite beverage.

Cart
Checkout - $0.00
  • 0
  • 1